ENGINE WORK  August, 2008

Aug 2 -  yet another Eggenfellner H6 owner tosses in the towel.

Aug 4 - shipped crank pulley off to Lindskog Balancing

Aug 7 - installed SDS crank sensor.  Looking over rest of SDS parts.  Laid out SDS display programming interface in panel.  Talked to someone who will lend me a 3 1/8" panel punch to make the hole.  Laid out where & how to mount SDS ECU.  3.0 hr

Aug 8 - got balanced pulley back from Lindskog.  Very quick turnaround.

Aug 12 - SDS ECU layout & mounting  3.0 hr

Aug 13 - punched hole for SDS panel display  0.5 hr

Aug 28 - SDS ECU and display  0.5 hr

Aug 29 - more work on SDS ECU, display, MAP unit mounting.  Grind down heads on AN525 screws so I can mount the SDS MAP unit.  Work on SDS main harness.  2.0 hr

 

go to September, 2008 engine page

 

BACK TO MY RV BUILDER'S HOME

BACK TO BRIAN'S HOME